“The time has come, the walrus said,
To talk of many things.
Of shoes and ships and sealing wax,
Of cabbages and kings.”
No plans yet to write about cabbages. But it is certainly time to talk about bespoke shoes. I set an appointment last week to go see George Glasgow at GJ Cleverley to be measured for my first pair. Rather as I did previously with suiting, expect a series of posts here on every stage of the process.
There’s something rather charming about being measured for shoes. At Cleverley the first stage is to stand on two facing pages of a book, so that your feet can be traced onto the paper. It feels rather odd standing on a book to begin with, but doing so in your socks in The Royal Arcade, while a man such as Mr Glasgow runs a pencil around your toes, is even more peculiar. Still, here stood stars of stage and screen alike – not to mention royalty.
When the shoemaker is tracing your foot the key is to keep the pencil upright. The smallest change in angle will mean a millimetre difference on the last, which can be the difference between comfort and pain.
He will also sweep around your instep, with the pencil at 45 degrees, in order to indicate the height of your arches. Looking back through the Cleverley measuring book, there is a substantial difference here between men. Some, like myself, have almost an inch in difference between the outline and the inside of the arch. (“Healthy and strong,” Mr Glasgow called it. He’s such a tease.) Others have merely a few millimetres. They will require greater support inside the shoe, and the waist will not be able to cut in quite as far underneath.
The length of your foot is also measured. At Cleverley this is done with a wooden rule dating back to 1928. It still looks in pretty good shape – no doubt due to the substantial brass fittings at the joint. While this length is a good guide for the shape of your last, it will always be made 1½ sizes longer than the measurement, to allow for your big toe rolling forward as you put your weight on the ball of your foot.
(As an aside, this difference is only one size on a slip-on shoe. It has no natural mechanism to tighten onto your foot, unless the model includes elastic at the sides, so the fit has to be tighter.)
Next the circumference of various points is measured. First your joints – between the base of your big and little toe. Then just behind the joints, to give an indication of how quickly the foot narrows. Next around your instep – roughly where the top of the laces would be. And finally from that same point on the top of the foot to the back of your heel.
The thing that struck me as these measurements were being taken was their consistentcy. At each point my right foot was 10-and-something inches, while my left was usually 9-and-something. Height just replaces width as you move towards the back of the foot.
It also put into numbers what I already knew, that my right foot is almost a half size smaller than my left, but significantly wider. While the first is very common, the latter together with a narrow heel makes me a good candidate for bespoke.
Finally, Mr Glasgow ran his hands over my ashamedly hot (not to say sweaty) feet. He was looking for any bumps or peculiarities, such as hammer toes, swollen joints (most common on the big and little toes) and spur bones around the heel.
Many of these are caused by men wearing ill-fitting shoes for much of their lives – or shoes that have not properly been worn in or maintained. Mr Glasgow found no such oddities, most likely because I am too young for my feet to have distorted much.
As a final point, some shoemakers insist on measuring a man’s feet at a particular point in the day. Your feet grow in size notably as you walk on them and keep them encased. Cleverly does not consider this significant, not even noting the time the measurements were taken. For Mr Glasgow the natural give of the leather is sufficient to cope with the daily fluctuation.
Next: styles and designs